Composed of alkyd resin, coloring pigments, physical pigments, drying agents, and solvents. The paint film is tough and bright, with bright colors, and has a certain degree of water and oil resistance; Poor weather resistance and color retention.
Design purpose
Suitable for the protection and decoration of indoor steel equipment, components, and wooden surfaces.
Physical parameters
Color: Various colors
Gloss: Shiny
Theoretical coating rate: 75-90g/㎡, 13.33 ㎡/L (based on 30 μ M dry film meter, excluding losses)
Specific gravity: approximately 1.0-1.2
Drying time: 23 ± 2 ℃: surface drying ≤ 4 hours, solid drying ≤ 24 hours
Flash point: 35 ℃
Storage period: 12 months
Construction instructions
Mixing ratio: single can
Maturation time: Open and stir well before use
Applicable period: unlimited
Construction method: high-pressure airless spraying, air spraying, manual brushing, roller coating
Diluent: X-6 Alkyd Paint Diluent
|
|
High pressure airless spraying |
Aerated spraying |
Manual brushing and roller coating |
|
Maximum dilution amount |
5% |
10% |
3% |
|
orifice |
0.38-0.46mm |
2.0-3.0mm |
- |
|
Ejection pressure |
15-20MPa |
0.3-0.4MPa |
- |
Tool cleaning: X-6 alkyd paint thinner
Paint film thickness: Wet film: 75 μ m. Dry film: 30 μ M
Painting interval
|
Substrate temperature |
5℃ |
20℃ |
30℃ |
| shortest |
48h |
24h |
20h |
| longest |
unlimited |
||
surface treatment
After long-term exposure of the previous paint surface in a polluted environment, use appropriate methods to remove all oil and debris from the paint surface.
Construction conditions: The temperature of the substrate must be 3 ℃ above the dew point, and the relative humidity must be less than 85%.
Front matching paint: H06-2 iron red cyclic ester primer, C141 iron red alkyd rust proof paint
Rear supporting coatings: C22-1 alkyd enamel (universal type), C22 alkyd enamel (weather resistant type), etc.
Packaging specification: 20 kilograms in an 18.5-liter container.
security
Avoid long-term inhalation of solvent vapors or paint mist, and do not come into contact with skin or eyes. When working in narrow or poorly ventilated areas, strong ventilation must be provided, and even if the ventilation conditions are good, protective equipment should be worn.
Notes
The above dry and wet film thickness refers to the indicators during high-pressure airless spraying;
The data related to this manual was obtained in the laboratory, and the actual product may differ slightly from it;
If there are any changes to the above data, the latest manual of our company shall prevail without prior notice.
