Product Description
The paint is composed of advanced fluorocarbon resin, additives, solvents, etc., and is packaged in two components: A and B. This coating has low viscosity, good construction performance, excellent light and color retention of the paint film, and excellent decorative effect.
Design purpose
Used for metal topcoat polishing.
Physical parameters
Color: Light yellow to colorless transparent liquid
Gloss: matte, high gloss
Theoretical coating rate: 40.0-60.0g/㎡ (based on 10 μ M dry film meter, excluding losses)
Specific gravity: 0.92-0.96
Volume solid content: 15.5%
Drying time: 23 ± 2 ℃: surface drying ≤ 1 hour, solid drying ≤ 24 hours
Complete curing: 23 ± 2 ℃: 7 days
Flash point: Component A 29 ℃
Storage period: 6 months
Construction instructions
Mixing ratio: A: B=3:1
Maturation time: Mix evenly according to the ratio before use
Applicable period: 12 hours
Tool cleaning: X-20 fluorocarbon coating thinner
Paint film thickness: wet film 40-50 μ m. Dry film 10 μ M
Painting interval: 23 ± 2 ℃: minimum 2 hours, maximum 48 hours
Front matching coating: C129 ultra weather resistant flashing metal fluorocarbon anti-corrosion topcoat
surface treatment
If the previous paint surface has been contaminated, appropriate methods should be used to remove grease and dust, or this paint thinner can be used to scrub.
Construction conditions: The temperature is 0 ℃ -35 ℃, the relative humidity is ≤ 85%, and the surface temperature of the coating should be above the dew point temperature by 3 ℃. Construction cannot be carried out under conditions of rain, fog, snow, and large dust.
Packaging specifications: 16 kilograms in a 20 liter container for component A, and 1 kilogram in a 3.4 liter container for component B. Add component B to component A in proportion.
matters needing attention
1. Before construction, the coated surface should be treated.
2. The tools used for construction should be clean and dry, and the paint should not be mixed with water or other impurities.
3. Before the paint film is completely dried and cured, protective measures should be taken to avoid being washed and trampled by rainwater and other liquids.
4. Store the coating in a low temperature, ventilated and dry place, away from heat sources, avoiding direct sunlight, and isolating sparks..
security
Please pay attention to the safety precautions on the packaging label. In addition, safety regulations stipulated by relevant national or local governments should also be followed. Avoid long-term inhalation of solvent vapors or paint mist. Skin and eyes should not come into contact with this product. When working in narrow or non ventilated areas, strong ventilation must be provided, and protective equipment should be worn during construction.
Notes
The data related to this manual was obtained in the laboratory, and may vary slightly during actual use due to changes in environmental conditions;
If there are any changes to the above data, the latest manual of our company shall prevail without prior notice.
